CW Process Instrumentation Store
37, Jalan Bayu 7/6,
Nusa Bayu 79200,
Iskandar Puteri,
Johor, Malaysia.
- Temperature
- Pressure
- Humidity
- Flow
- Vibration
- Ex-proof Intrinsically Safe
- Level
- Signal Converter & Signal Isolator
- Paperless Recorder & Smart Process Indicator
- Encorder & Linear Sensor
- Load Cell Weighing Sensor & Weighing Indicator
- Measurement & Control Device
- Handheld Instruments
- HMI (Human Machine Interface)
- Genset Controller & Charger
- Networking Switch
- Industrial Power Supply
- Inductive & Photo Sensor
- Connecting Cable & Connector
- Climate Control & Lighting
- Electrical Component
- Variables Speed Drives (Inverter) & Soft Starter
- Industrial Control Panel
- Batch Counter
- CLASS 1 CT
- Digital Indicator
- Digital Voltmeter & Ammeter
- Humidistats and condensation controllers
- Humidity and Temperature Sensors
- Humidity temperature sensor DWK
- Limit Switch Box
- Magnetic Pickup Sensor
- PANEL MEASURING INSTRUMENTS
- PLC
- POWER Meter & kWH meter
- Safety Modules / Safety Relays
- Safety Switch & Safety Sensor
- SENSOR
- SIGNAL TRANSDUCERS
- Transmitter for humidity and temperature DZK
- Others
EPS-MT-KSK
|
EPS-MT-KSKRM 860.00 1 In Stock
Quantity
Booster stations
Domestic waterworks
Garden pumps
Sprinkle irrigation units
The electronic pump control EPS-MT combines the function of both mechanical pressure switch and flow-control (dry running protection) in one unit.
The EPS-MT controlsand protects AC-powered pumps convincingly. The application range is limited to pumps with a max. pressure of up to 10 bar,
for higher operating pressures a pressure-reducing regulator has to be installed on the intake side.The readiness for operation is indicated
by a green LED. Failures are displayed by a red LED.
Directly after connection to the electrical power supply the pump will start automatically and the EPS-MT will immediately take over the control function. If the piping system is under pressure, but no flow is detected, the EPS-MT will cut off the pump after a short time delay.
If the system pressure decreases below the preadjusted start-up pressure (factory setting 1,5 bar) the pump will restart. In case of no pressure and flow is detected after the pump restart, the EPS-MT will identify this status within short time as „dry running“ and switch off the pump.
At frequent intervals of 60 minutes the pump control automatically checks for sufficient amount of water in the system.
If enough water is detected, the EPS-MT will reset to normal operating modus. After four repeating attempts without sufficient water in the system
the pump control finally performs the troublecode „dry-running“ and must then be resetted manually.
The system pressure is displayed by the integrated bolt-on manometer.
Download Files
|